![]() ![]() Took me a bit to figure it out and it works well. Since I have the Voswitch I just ran the thin red wire to it for +12v (or not) and use its remote switches in the cab. Since I am not using air lockers or the cool ARB lighted toggle switch I used no other connections - isolated them with electrical tape and wrapped them with tape to harness.Įdit - after rereading above I see that you are using a lighted switch and provides a great schematic for that setup. Conveniently mounted in a durable carry case. Heavy duty maxi-fuse equipped for professional in-line circuit protection. Motor is internally thermal protected against extreme temperature damage. The enclosure mounts under or without the Trail Rails on. Features: Portable 12V DC air compressor with 6m (20ft) tyre inflation hose. If your setup is similar to mine the thin red wire is the important one to wire to your switch that provides +12v. Jeep Gladiator Bed Side Compressor Enclosure for the ARB Single or Twin Compressor. You can connect your air hose to get a longer run time before pressure switch trips. The high price point stems from the motors, both of which are water sealed and ball-bearing equipped (no bushings here). It is constructed with aerospace and military-grade components that provide durability. If you do the same without connecting thin red to +12v the compressor should not run. This ARB portable air compressor is compact (17.3 x 9.8 x 8.7 inches) and heavy (16 pounds). Should run compressor until pressure switch kicks in and stops it. Temporarily - run reds mentioned to positive battery, run blacks mentioned to negative battery. ![]() ![]() Wire up compressor and pressure switch to connectors per instructions. On the opposite end of the main cable the thin red wire goes to your switch that provides +12vĮasy to test. High pressure cutoff leads to pressure switch mounted to compressor - does not matter what connector each is connected to. Thick black and thick red to battery, thin black to battery - per instructions.Ĭompressor power cable/fitting to compressor power fitting. Wired ARB single to Voswitch switchbox a couple days ago - no air lockers, just compressor functionality for airing upĭid not need secondary wiring harness so it’s in the box (the one that would run into the switches in the cab) ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |